Fuji Software Resets

To execute the below key combinations, simultaneously press and hold the N (where N is the number displayed below), the Stop, and the Power Save buttons on the Control Panel while switching on the power. Hold the buttons down until the boot up screen (5 circles) appears and the second circle starts to blink.

 

Log Initialization - 1/Stop/PowerSave

This step will delete any print or copy job that is in process, and then perform a reboot.

 

Spool Initialization - 6/Stop/PowerSave

This step will delete all pending print or copy jobs in the job queue, and then perform a reboot.

 

HDD Initialization - 4/Stop/PowerSave

This step will delete all pending print or copy jobs in the IOT job queue (does not delete jobs stored on an external RIP), initializes the IOT HDD and will and then perform a reboot. All customer data on the HDD will be deleted. This will delete Machine Certificates and any EIP Registrations made on the device. You may wish to print a configuration report and take a clone of the device before attempting this.

 

ESS NVM Initialization - !!CAUTION!! - 3/Stop/PowerSave

This routine will set all IOT ESS NVM values to default. DO NOT attempt this procedure unless there is a known-good Machine Settings floppy, an accurate Configuration Report and/or other data that will enable you to reload the correct NVM values for this machine. This may be found in the hidden compartment in one of the Trays.

This step will initialize the IOT ESS NVM (SYS-System and SYS-User) and then perform a reboot. You may wish to print a configuration report and take a clone of the device before attempting this.

pan> A�


NOTE: Was not able to get HDD Initialization working on a 560 on latest SPAR - Jan 2015